Designation of KIP WORM MOTOR

Gearbox> Worm Reducer and Worm Motor

3. Selection

1.Features of the EG Worm Reducer 2.Designation and Location of Input Shaft
	2-1)Designation 2-2)Transmission Ratio 2-3)Symbols of Designatio n
3. Selection
	3-1) How to Select Proper Worm gear moto r 3-2) Other Consideration for Selection 3-3) Standard Specification of Motor 3-4) Data table of Reducer Selection
4. Convenient Technical Formulas
5. Service Factor
6.Over Hung Load
7.Backlash and Installation
8.Lubrication and Maintenance
9.Nominal Transmission Ratio,Power and Torque
10.Designs,Dimensions and Mounting Position
11.Accessories for The Mounting
	11-1) Foot Plate and Vertical Flange 11-2) Torque Arm
12. Table of Bearing and Oil Seal
13. Designs and Dimensions of Motor
14.Example of Mounting
15.Drawing Room

3-1) How to Select Proper Worm gear motor

For the proper selection of required gear motors and gear box unit, make all available necessary data.

▶Calculate required output torque (T₁) or Power (kW)
Refer to Convenient Formula for the relations among the Torque(T₁),Power (kW) and Horse Power(HP)

▶Calculate required output shaft speed(n2) and input shaft speed (n1) or transmission ratio
Refer to Convenient Formul a for the relations among the Output Speed ,Input Speed and Reduction ratio

▶Determine the service factor
Refer to the Service Factor

▶Select the proper gear motor or reducer size on the basis of torque (T₁) greater than or equal to T₁x Sf on
CH.9 Table of nominal transmission ratio , power and torque.

T≥T₁ XSf

where

T= nomunal torque
T₁=load torque
Sf=service factor

▶Verify permissible over hung load by referring to the instructions and values specified on CH.6 Over Hung Load
If there are over loads, verify that the maximum torque is always less than the O.H.L. values specified on this catalogues.
You have to consider that over loads are caused by low transmission ratio, high force of interia, braking, higher power than required and other dynamic and static loads.
If you have any questions or severe operating conditions, consult us.

▶By nominating location and direction of output shaft and selecting the follow options, you have completed the selection.

Options :Foot Plate, Flange Torque Arm
Foot Plate, Flange	Torque Arm
Motor

☞ Note
If □ for options and motor specification are remained in blank ,the options and motors are not supplied by us.